Durability of a repaired dune sand mortar modified by ceramic waste
Abstract
The waste-modified mortars have an important place in the range of repair products. The objective of this study is to better understand and analyze, in one hand, the influence of ceramic waste in the dune sand mortars on the quality of repair concrete surfaces, in the other hand, durability of the mortars in interaction with the substrates to which they are applied. As regards the mortar layer durability, two indicators are chosen: the first is the adhesion to the substrate, and the second is the stress state in the mortar layer. For this, two types of modified mortars were made using two types of waste ceramics: sanitary ceramics and earthenware. To evaluate the quality of the adhesion to a substrate surface to be repaired, an adhesion test based on the three point bending test was implemented, taking into account the influences of the environment, the state of the surface of the substrate, the nature of the substrate defined by its water saturation degree and its porosity. The mortar composition parameters, in particular, the nature and the amount of ceramic, were studied. The results enable us to evaluate the influences of the waste ceramic incorporation in the mortar and the substrate condition on which the mortar is applied. Show that the adhesion depends on both the type and the amount of the used ceramic waste and the applied cure. It is optimized from 30% of ceramic earthenware and sanitary mortar adhesive strengths are higher than mortars based on dune sand ones.
Keyword : dune sand, ceramic waste, repair mortar, adhesion, mechanical strength, durability
This work is licensed under a Creative Commons Attribution 4.0 International License.
References
Abadou, Y., Mitiche-Kettab, R., & Ghrieb, A. (2016). Ceramic waste influence on dune sand mortar performance. Construction and Building Materials, 125, 703-713. https://doi.org/10.1016/j.conbuildmat.2016.08.083
Bijen, J., & Salet, T. (1994). Adherence of young concrete to old concrete developement of tools in civil engineering, in Adherence of young and old concrete. Proceedings of 2nd Bolomey Workshop (pp.1-24). Unterengstringen.
Czarnecki, L. (2008). Adhesion – a challenge for concrete repair concrete repair. 2nd International conference on concrete repair, rehabilitation and retrofitting (ICCRRR) (pp. 95-940). Cape Town, South Africa. https://doi.org/10.1201/9781439828403.sec11
Courard, L. (2000). Parametric study for the creation of the interface between concrete and repair products. Materials and Structures, 33, 65-72. https://doi.org/10.1007/BF02481698
Courard, L. (1998). Contribution to the analysis of parameters influencing the creation of the interface between concrete and repair systems. University of Liège.
Corinaldesi, V., & Moriconi, G. (2009). Behaviour of cementitious mortars containing different kinds of recycled aggregate. Construction and Building Materials, 23, 289-294. https://doi.org/10.1016/j.conbuildmat.2007.12.006
Corinaldesi, V., Giuggiolini, M., & Moriconi, G. (2002). Use of rubble from building demolition in mortars. Waste Management, 22, 893-899. https://doi.org/10.1016/S0956-053X(02)00087-9
Darque-Ceretti, E., & Felder, E. (2003). Adhésion et adhérence (388 p.). CNRS édition, Sciences et Technique de l’ingénieur. ISBN 2271060923.
EN 197-1:2000. Cement. Part 1: composition, specifications and conformity criteria for common cements.
EN 196-1:2005. Methods of testing cement – Part 1: Determination of strength; 2005.
EN 1015-12. Methods of test for mortar for masonry – Part 12: Determination of adhesive strength of hardened rendering and plastering mortars on substrates. European Committee for Standardization (CEN); February 2000.
Farinha, C., de Brito, J., & Veiga, J. R. (2015). Incorporation of fine sanitary ware aggregates in coating mortars. Construction and Building Materials, 83, 194-206. https://doi.org/10.1016/j.conbuildmat.2015.03.028
Fiebrich, M. H. (1994). Scientific aspects of adhesion phenomena in the interface mineral substrate-polymers, in Adherence of young and old concrete. Proceedings of 2nd Bolomey Workshop (pp. 25-58). Unterengstringen.
Guangiing, X., Jinwei, L., & Gengying, L. (2002). A way for improving interfacial transition zone between concrete substrate and repair materials. Cement and concrete Research, 32, 1877-1881. https://doi.org/10.1016/S0008-8846(02)00840-2
Gomes, M., & de Brito, J. (2009). Structural concrete with incorporation of coarse recycled concrete and ceramic aggregates: durability performance. Materials and Structures, 42, 663-675. https://doi.org/10.1617/s11527-008-9411-9
Halicka, A., Ogrodnik, P., & Zegardło, B. (2013). Using ceramic sanitary ware waste as concrete aggregate. Construction and Building Materials, 48, 295-305. https://doi.org/10.1016/j.conbuildmat.2013.06.063
Jiménez, J. R., Ayuso, J., López, M., Fernández, J. M., & de Brito, J. (2013). Use of fine recycled aggregates from ceramic waste in masonry mortar manufacturing. Construction and Building Materials, 40, 679-690. https://doi.org/10.1016/j.conbuildmat.2012.11.036
Julio, E. N. B. S., Branco, F. A. B., & Silva, V. D. (2004). Concrete-to-concrete bond strength. Influence of the roughness of the substrate surface. Construction and Building Materials, 18(9), 675-681. https://doi.org/10.1016/j.conbuildmat.2004.04.023
López, V., Llamas, B., Juan, A., Morán, J. M., & Guerra, I. (2007). Eco-efficient concretes: impact of the use of white ceramic powder on the mechanical properties of concrete. Bio systems Engineering, 96, 559-564. https://doi.org/10.1016/j.biosystemseng.2007.01.004
Lucas, J., de Brito, J., Veiga, R., & Farinha, C. (2016). The effect of using sanitary ware as aggregates on rendering mortars performance. Materials and Design, 91, 155-164. https://doi.org/10.1016/j.matdes.2015.11.086
Ledesma, E. F., Jimenez, J. R., Ayuso, J., Fernandez, J. M., & de Brito, J. (2015). Maximum feasible use of recycled sand from construction and demolition waste for eco-mortar production e Part-I: ceramic masonry waste. Journal of Cleaner Production, 87, 692-706. https://doi.org/10.1016/j.jclepro.2014.10.084
Medina, C., Frías, M., Sánchez, M. I., & de Rojas, M. I. (2012a). Microstructure and properties of recycled concretes using ceramic sanitary ware industry waste as coarse aggregate. Construction and Building Materials, 31, 112-118. https://doi.org/10.1016/j.conbuildmat.2011.12.075
Medina, C., Sánchez de Rojas, M. I., & Frías, M. (2012b). Reuse of sanitary ceramic wastes as coarse aggregate in eco-efficient concretes. Cement and Concrete Composites, 34, 48-54. https://doi.org/10.1016/j.cemconcomp.2011.08.015
Matias, G., Faria, P., & Torres, I. (2014). Lime mortars with ceramic wastes: characterization of components and their influence on the mechanical behaviour. Construction and Building Materials, 73, 523-534. https://doi.org/10.1016/j.conbuildmat.2014.09.108
Momayez, A., Ehsani, M. R., Ramezaniapour, A. A., & Rajaie, H. (2005). Comparison of methods for evaluating bond strength between concrete substrate and repair materials. Cement and Concrete Research, 35, 748-757. https://doi.org/10.1016/j.cemconres.2004.05.027
Pincha, T., & Arnon, C. (2010). Utilization of ceramic waste as fine aggregate within Portland cement and fly ash concretes. Cement and Concrete Composites, 32, 440-449. https://doi.org/10.1016/j.cemconcomp.2010.02.004
Silva, B. A., Ferreira Pinto, A. P., & Gomes, A. (2015). Natural hydraulic lime versus cement for blended lime mortars for restoration works. Construction and Building Materials, 94, 346-360. https://doi.org/10.1016/j.conbuildmat.2015.06.058
Silva, J., de Brito, J., & Veiga, R. (2010). Recycled red-clay ceramic construction and demolition waste for mortars production. Journal of Materials in Civil Engineering, 22, 236-244. https://doi.org/10.1061/(ASCE)0899-1561(2010)22:3(236)
Silva, J., de Brito, J., & Veiga, R. (2009). Incorporation of fine ceramics in mortars. Construction and Building Materials, 23, 556-564. https://doi.org/10.1016/j.conbuildmat.2007.10.014
Tchetgnia, N., Marceau, S., & Chaussadent, T. (2013). Durability of repairs of reinforced concrete structures with modified mortars by polymers. 31èmes Rencontres de l’AUGC, E.N.S. Cachan, 29 au 31 Mai.
Zimbili, O., Salim, W., & Ndambuki, M. (2014). A Review on the usage of ceramic wastes in concrete production. International Journal of Civil, Environmental, Structural, Construction and Architectural Engineering.