Department of Geotechnics and Coastal Engineering, Faculty of Agricultural and Environmental Sciences, Universität Rostock, Justus-von-Liebig-Weg 6, 18059 Rostock, Germany
Department of Geotechnics and Coastal Engineering, Faculty of Agricultural and Environmental Sciences, Universität Rostock, Justus-von-Liebig-Weg 6, 18059 Rostock, Germany
In the project DredgDikes with partners from Poland and Germany different dredged materials from the South Baltic Sea region are investigated with respect to their application in dike construction. Two large-scale experimental dikes have been built, one in Germany and one in Poland. Additionally, an extensive laboratory testing programme has been realised and a considerable monitoring test programme will be followed. Based on a short general description of the project this paper covers the issue of installation technology for the dredged materials used and a discussion of geotechnical parameters to be determined for material evaluation and quality control. Due to the high and variable natural water contents of the organic soils together with their inhomogenous composition the compactability is difficult to predict and proctor values may not be reliably determined. During the installation three different compaction technologies were compared and no extreme differences could be found, which is why the compaction with a caterpillar was chosen for efficiency on site. The critical analysis of the data, however, shows slightly better compaction results for the roller compactors. In general the degree of compaction was comparably low. Therefore, different possibilities to improve compaction are discussed in this paper, such as the homogenisation of the dredged material by simple in situ mixing technologies, which will be issues for further research.
Cantré, S., & Saathoff, F. (2014). Installation of fine-grained organic dredged materials in combination with geosynthetics in the German DredgDikes research dike facility. Engineering Structures and Technologies, 5(3), 93-102. https://doi.org/10.3846/2029882X.2013.869411
Authors who publish with this journal agree to the following terms
that this article contains no violation of any existing copyright or other third party right or any material of a libelous, confidential, or otherwise unlawful nature, and that I will indemnify and keep indemnified the Editor and THE PUBLISHER against all claims and expenses (including legal costs and expenses) arising from any breach of this warranty and the other warranties on my behalf in this agreement;
that I have obtained permission for and acknowledged the source of any illustrations, diagrams or other material included in the article of which I am not the copyright owner.
on behalf of any co-authors, I agree to this work being published in Engineering Structures and Technologies as Open Access, and licenced under a Creative Commons Licence, 4.0 https://creativecommons.org/licenses/by/4.0/legalcode. This licence allows for the fullest distribution and re-use of the work for the benefit of scholarly information.
For authors that are not copyright owners in the work (for example government employees), please contact VILNIUS TECHto make alternative agreements.
